View Full Version : jointer question
Greg Tatum
06-07-2005, 8:30 PM
Does a slightly scalloped surface on the edge of a board mean that one or two knives are higher than the other?
TIA
Regards,
Greg
Jim Becker
06-07-2005, 9:15 PM
Yup...it does.
lou sansone
06-07-2005, 9:31 PM
the only other possibility might be that you were using excessive feed speed. Did you just notice this or have you just changed your blades.
lou
Greg Tatum
06-07-2005, 10:40 PM
the only other possibility might be that you were using excessive feed speed. Did you just notice this or have you just changed your blades.
lou
I did just notice it but I haven't used my jointer in a very long time....I just face-jointed a board and I can see the same thing, just much shallower. Thanks for the input Jim and Lou.
Greg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.