Rich Kruyer
11-21-2013, 9:03 PM
I am trying to cut some 1/8" thick acrylic material I applied some double sided tape to the back of the object so that the tape would be cut at the same time as the acrylic. Problem is I keep burning the tape. The double sided tape is 2" wide tape from JDS with a yellowish colored backer. Is there a better tape to use or different procedure?
I also have a customer that brought some material by that is reverse engraved. The front has a frosted texture to it and is approximately .040" thick any ideas on what this material is? Also they use a double sided tape to adhere it the machinery with one piece of tape that is 12" x 12" any idea where I can purchase this?
My laser is a GCC mercury 35 watt.
Thanks,
Rich
I also have a customer that brought some material by that is reverse engraved. The front has a frosted texture to it and is approximately .040" thick any ideas on what this material is? Also they use a double sided tape to adhere it the machinery with one piece of tape that is 12" x 12" any idea where I can purchase this?
My laser is a GCC mercury 35 watt.
Thanks,
Rich