Marcel LeBlanc
11-21-2013, 2:17 AM
Hi to all of you.
I have General International table saw with a homemade sliding table (one that is similar to the Excalibur) running on four Thomson SPBOPN bearing, I recently change the arbor bearing and since then when I am cross cutting with the sliding table I am getting burns on the right side of the stock that I am cutting.
To readjust the sliding table I made the five cut method using a sheet of melamine 3x3 foot and the last cut gives me difference between the front and back of .005 inch, so I assume it is square enough.
The blade is perfectly parallel with the miter slot.
What else should I check?
Thank you
I have General International table saw with a homemade sliding table (one that is similar to the Excalibur) running on four Thomson SPBOPN bearing, I recently change the arbor bearing and since then when I am cross cutting with the sliding table I am getting burns on the right side of the stock that I am cutting.
To readjust the sliding table I made the five cut method using a sheet of melamine 3x3 foot and the last cut gives me difference between the front and back of .005 inch, so I assume it is square enough.
The blade is perfectly parallel with the miter slot.
What else should I check?
Thank you