View Full Version : Toggle Between Positive & Negative imgages
Roger Lueck
11-19-2013, 12:31 AM
If there is a need to engrave a positive image and then engrave a negative image of the same file or object, is there a "toggle command" that can be used to change a file or object in a file between a postive image and a negative image?
Dan Hintz
11-19-2013, 5:48 AM
Depends upon your laser system... many have a checkbox that allows you to print positive/negative images. Otherwise, you'll need to do it in a graphics program before sending it over.
Mike Null
11-19-2013, 8:47 AM
I can't think of a reason you would need to engrave both. As Dan says, your graphics program should permit you to toggle.
In Corel under the effects menu you can select invert.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.