Bob Noles
06-05-2005, 4:02 PM
Just to let SMC know that I do a little working between asking so many questions, I thought I would share a couple of pictures of a router table I am in the middle of finishing. I know I promised Tim some shots a few days ago in another post.
I am open to any suggestions or constructive critisim before I get any further along and can adjust. Hardware is not on the doors yet and still many last minute details to acomplish. The left door will be temporary as I hope to add drawers in it's place later on. I may cut re-cut the right door so the upper RH door will cover the hole next to the switch.
Constructed mostly from 3/4 oak ply with Rockler Table top and extension wings. Dust collector port/chute not in place yet, but it's coming ;) Plan on finishing in Golden Oak stain (upper doors are example) with many coats of wipe on poly.
LOML says not to add center trim to upper doors, what do you folks say?
I Know I am a newbie so please go easy on any mistakes you see :p
I am open to any suggestions or constructive critisim before I get any further along and can adjust. Hardware is not on the doors yet and still many last minute details to acomplish. The left door will be temporary as I hope to add drawers in it's place later on. I may cut re-cut the right door so the upper RH door will cover the hole next to the switch.
Constructed mostly from 3/4 oak ply with Rockler Table top and extension wings. Dust collector port/chute not in place yet, but it's coming ;) Plan on finishing in Golden Oak stain (upper doors are example) with many coats of wipe on poly.
LOML says not to add center trim to upper doors, what do you folks say?
I Know I am a newbie so please go easy on any mistakes you see :p