Tom O'Donnell
06-05-2005, 12:19 AM
I may have suggested this before Why do we not have a Forum on Routing where all the routing questions can be in one area.
Looking through the postings there is little on the use of the router.
I have enclosed some pics on routing to start the ball rolling The diagram is a handle to be used on bedroom furniture and I was asked if it could be cut with the router. It is possible with a CNC router but what about in the Router Table or Plunge Routing. I would be interested in your comments and suggestions I certainly will be looking at the problem over the next few days. (I cannot resist a challenge) how about you? Pass on your thoughts and I will forward my results later.
The two other pics show small mantle clock 280mm long x 120mm high and a dish 300mm x 180mm x 30mm hollowed out to a depth of 27mm.
Tom
Looking through the postings there is little on the use of the router.
I have enclosed some pics on routing to start the ball rolling The diagram is a handle to be used on bedroom furniture and I was asked if it could be cut with the router. It is possible with a CNC router but what about in the Router Table or Plunge Routing. I would be interested in your comments and suggestions I certainly will be looking at the problem over the next few days. (I cannot resist a challenge) how about you? Pass on your thoughts and I will forward my results later.
The two other pics show small mantle clock 280mm long x 120mm high and a dish 300mm x 180mm x 30mm hollowed out to a depth of 27mm.
Tom