Anthony Diodati
11-01-2013, 11:28 AM
I wanted to do the outfeed table like woodsmith had with the http://assets.rockler.com/media/catalog/product/cache/1/small_image/80x/9df78eab33525d08d6e5fb8d27136e95/2/1/21910-02-1000.jpg
Magswitch MagJig 150 (40mm) devices, but didn't want to spend the $37.00 each for the magnets.
I just used two 1" rare earth magnets J-B welded onto counter bored holes.
It is just resting on a roller stand right now, I have to come up with a single leg for the rear, that can be disconnected and stuck in a corner when not in use.
I think it will work out OK, if not, I need to find another way to attach it, maybe 5/16" studs coming out of the rear rail, with those threaded knobs things you use for jigs to act as the nut to bolt it down.
Magswitch MagJig 150 (40mm) devices, but didn't want to spend the $37.00 each for the magnets.
I just used two 1" rare earth magnets J-B welded onto counter bored holes.
It is just resting on a roller stand right now, I have to come up with a single leg for the rear, that can be disconnected and stuck in a corner when not in use.
I think it will work out OK, if not, I need to find another way to attach it, maybe 5/16" studs coming out of the rear rail, with those threaded knobs things you use for jigs to act as the nut to bolt it down.