View Full Version : Corel Draw Print Merge Help needed

Don Williams Michigan
10-16-2013, 8:28 PM
I am having problems with an industrial tag order.

I am using X3.

About 600 machine tags that are labeled with different codes. No matter how I save the Excel spread sheet I cannot get print merge to properly center all of the codes? Some are centered, but many are not?

I have googled, you tubed, and searched but cannot figure out a fix?

Examples of the various data is:


Any and all advice to fix this is greatly appreciated!

Mike Null
10-17-2013, 6:57 AM
Roy Brewer at Engraving Concepts has a couple of tutorials on his site that may help. http://www.engravingconcepts.com/index.php?option=com_content&view=article&id=20&Itemid=67

Don Williams Michigan
10-17-2013, 8:39 AM
Mike, thanks for the reply.

Problem is solved. I was adding an envelope (per an old tutorial) that was not needed. After removing it, all is well.

Chris Edens
10-17-2013, 8:40 AM
If you do a lot of print merging go ahead and get the name it software from laser jumps start. It's easier to use and it removes extra steps. You can also merge over multiple sheets. I use it to fill in data for thousands of stamp designs in seconds.