Rick Caudill
10-07-2013, 4:18 PM
We have a V-460 Universal Laser. The problem I am having is with the Z table adjust. It just stops moving at random times. Sometime it is while going up and sometime while going down. There is not a pattern or certain spot where it stops. Also sometimes the motor sound (or speed) will change. When the motor stops it will not move again in the same direction until you move it in the other direction first.
Here is what I have tried. Cleaned and re-lubed the lift screws. Checked the table for level, checked the motor connections and checked the belts tension. I cannot find anything that is binding or loose. When the motor is running slow if I pull pulled on the lower belt to aid the motor it does not help. The motor just keeps moving at the same rate.
Any suggestions?
Here is what I have tried. Cleaned and re-lubed the lift screws. Checked the table for level, checked the motor connections and checked the belts tension. I cannot find anything that is binding or loose. When the motor is running slow if I pull pulled on the lower belt to aid the motor it does not help. The motor just keeps moving at the same rate.
Any suggestions?