Robert Silvers
10-01-2013, 12:14 PM
I have PhCAD and then there is the control panel - Triumph Laser 900x600 with a 5200 chiller - which I am not sure what controller it is, but probably the same as most others.
First, I am loving this laser. They shipped it with the tube in place, and all aligned, and it just worked with no setup. It is a 100 watt Z4 RECI tube, and at 100% power and a slow speed like in the 10-100mm/sec range, it will mark steel quite well.
But setting the Z height and just moving the X/Y to where I want to start, it moves too quickly, so I cannot control where it goes precisely enough.
I cannot find the setting to slow this down.
First, I am loving this laser. They shipped it with the tube in place, and all aligned, and it just worked with no setup. It is a 100 watt Z4 RECI tube, and at 100% power and a slow speed like in the 10-100mm/sec range, it will mark steel quite well.
But setting the Z height and just moving the X/Y to where I want to start, it moves too quickly, so I cannot control where it goes precisely enough.
I cannot find the setting to slow this down.