Ben Levesque
09-27-2013, 3:41 PM
I am wondering if someone here have a drawing of a (truck air horn) and a vector 3D soft, so that they could generate a flat view of the horn in multiple shades of gray)
I'm pretty good regarding 3D engraving, curves, pipes, hydraulic cylinders & roofs posts, but this "dam" air horn is really hard to draw in different tone of gray when using Corel draw.
And I don't want to buy an expensive software like Aspire to generate a 3D view of grey shades, for only one part, especially since it will only be 1/8" long.
So if anyone can generate this 2d view in gray., I would be very grateful.
Here's an example of what I am searching for. But a air horn instead of pipes, with the same shade of gray pattern, as seen here, white on top of the pipes (white = untouch by the laser) and more dark grey on the side, this generate some half sections of pipes or cylinders that you can attach together to form a complete piece.
https://lh3.googleusercontent.com/-1Dh6kx7QhMI/UkXb0ksbcPI/AAAAAAAAAEU/CQAzkh3AnSc/s512/pipes.jpg
Those goes on the miniature vehicles bellow that are 100% made with an Engraver.
https://lh4.googleusercontent.com/-E-85K0-Dk-g/Uj-HJu6285I/AAAAAAAAA4I/6_uBDTRkar4/s912/Updates_1.jpg
Thanks
Ben
I'm pretty good regarding 3D engraving, curves, pipes, hydraulic cylinders & roofs posts, but this "dam" air horn is really hard to draw in different tone of gray when using Corel draw.
And I don't want to buy an expensive software like Aspire to generate a 3D view of grey shades, for only one part, especially since it will only be 1/8" long.
So if anyone can generate this 2d view in gray., I would be very grateful.
Here's an example of what I am searching for. But a air horn instead of pipes, with the same shade of gray pattern, as seen here, white on top of the pipes (white = untouch by the laser) and more dark grey on the side, this generate some half sections of pipes or cylinders that you can attach together to form a complete piece.
https://lh3.googleusercontent.com/-1Dh6kx7QhMI/UkXb0ksbcPI/AAAAAAAAAEU/CQAzkh3AnSc/s512/pipes.jpg
Those goes on the miniature vehicles bellow that are 100% made with an Engraver.
https://lh4.googleusercontent.com/-E-85K0-Dk-g/Uj-HJu6285I/AAAAAAAAA4I/6_uBDTRkar4/s912/Updates_1.jpg
Thanks
Ben