Jog to defined location

[Bruce Dorworth]

I am using laser cut 5.3. I would like to install a template jig on my table. The center of this jig is say 57,94. From 0,0 Is there some way to tell the laser to go to 57,94?

Thanks,
Bruce

[George M. Perzel]

Bruce;
I am not familiar with Lasercut but have been told that Laserwork is similar. In Laserwork there is a TEST tab on the right. Under that tab is a click on box "Current Laser4 Position". Clicking that will tell you the current X and Y coordinates for the head. Under that is a stucture which allows you to move the head in either direction by a amount in mm which you determine. Once you know where the head is, subtracting that from the desired coordinate will give you the move amount.
Best Regards,
George
Laserarts

[Earl Cox]

Call Ray Scott at Rabbit laser USA, he'll be able to tell you.

[Dennis Watson]

Goto top of Lasercut and pick the origin button. A window opens and type in the X Y that you need.