View Full Version : Jog to defined location

Bruce Dorworth
09-27-2013, 2:35 AM
I am using laser cut 5.3. I would like to install a template jig on my table. The center of this jig is say 57,94. From 0,0 Is there some way to tell the laser to go to 57,94?


George M. Perzel
09-27-2013, 7:18 AM
I am not familiar with Lasercut but have been told that Laserwork is similar. In Laserwork there is a TEST tab on the right. Under that tab is a click on box "Current Laser4 Position". Clicking that will tell you the current X and Y coordinates for the head. Under that is a stucture which allows you to move the head in either direction by a amount in mm which you determine. Once you know where the head is, subtracting that from the desired coordinate will give you the move amount.
Best Regards,

Earl Cox
09-28-2013, 9:32 AM
Call Ray Scott at Rabbit laser USA, he'll be able to tell you.

Dennis Watson
09-28-2013, 11:07 AM
Goto top of Lasercut and pick the origin button. A window opens and type in the X Y that you need.