Howard Boehm
09-19-2013, 10:29 AM
This is my second table for the outside dining area.
271204
African Mahogany Top
271205
Cut my 6x6 and did a lap joint on the cross members
271206
Cut up another of my wife's cutting boards from the kitchen. Cut into squares and beveled edges. Counter sunk Screws. Cheapest way to get poly carbonate feet for table. Cost of board at Wal-Mart $2.97
271207
Attached Cross Members to Legs
271208
Clamped a couple boards to top cross member to hold it while I clamped it.
271209
I am using 1/2 Inch x 12 inch Lag screws. Pre drill with 3/8" bit and then use impact drive to attached. This is easier than driving a nail.
271210
Clamped in place ready to drive Lag Screws in.
271211
Holes for umbrella. Wind will not blow this over ever.
271204
African Mahogany Top
271205
Cut my 6x6 and did a lap joint on the cross members
271206
Cut up another of my wife's cutting boards from the kitchen. Cut into squares and beveled edges. Counter sunk Screws. Cheapest way to get poly carbonate feet for table. Cost of board at Wal-Mart $2.97
271207
Attached Cross Members to Legs
271208
Clamped a couple boards to top cross member to hold it while I clamped it.
271209
I am using 1/2 Inch x 12 inch Lag screws. Pre drill with 3/8" bit and then use impact drive to attached. This is easier than driving a nail.
271210
Clamped in place ready to drive Lag Screws in.
271211
Holes for umbrella. Wind will not blow this over ever.