Roger Feeley
09-10-2013, 3:52 PM
Has anybody seen this movie (http://www.crushgrind.ca/downloads/CrushGrind%20Inner%20Groove%20Video.3gp)?
http://www.crushgrind.ca/downloads/CrushGrind%20Inner%20Groove%20Video.3gp
They are using a keyhole router bit to mill an internal slot. That movie scares the heck out of me. There has to be a better way.
You have a 25mm hole in the middle and you have to mill a slot 2.5mm deep 15mm from the end. Woodcraft sells a special lathe tool that you maneuver into the hole and make the cut.
http://www.crushgrind.ca/downloads/CrushGrind%20Inner%20Groove%20Video.3gp
They are using a keyhole router bit to mill an internal slot. That movie scares the heck out of me. There has to be a better way.
You have a 25mm hole in the middle and you have to mill a slot 2.5mm deep 15mm from the end. Woodcraft sells a special lathe tool that you maneuver into the hole and make the cut.