Nathan Shaffer
09-02-2013, 12:10 AM
269967
This project has three types of burns. The burn on the left is a vector, machine traced the lines of the image. The shell is rastered. The two circles are supposed to be a single hole. After discovering the miss burn I rechecked my file for hidden objects. Then did another test, got the same thing again. redid the file, then burned it. same thing happened a third time, but this time i was watching a discovered, that the beam was splitting into two. I checked mirrors and lens are not cracked. I changed from 2 inch focal lens and nose cone, to a 1.5 lens and cone. ran the job again. Had no problems with the job.
Any Ideas?
Thank you in advance!
Nathan
This project has three types of burns. The burn on the left is a vector, machine traced the lines of the image. The shell is rastered. The two circles are supposed to be a single hole. After discovering the miss burn I rechecked my file for hidden objects. Then did another test, got the same thing again. redid the file, then burned it. same thing happened a third time, but this time i was watching a discovered, that the beam was splitting into two. I checked mirrors and lens are not cracked. I changed from 2 inch focal lens and nose cone, to a 1.5 lens and cone. ran the job again. Had no problems with the job.
Any Ideas?
Thank you in advance!
Nathan