Bill Brush
08-28-2013, 4:31 PM
I figured I would make a new thread for this since it probably got lost in the shuffle of the other thread.
I got a wooden plane body from my father-in-law's garage, no iron, no wedge. It is a tiny little thing but I'd like to make it functional. The mouth has rounded ends like it was either drilled or routered out and the flat part is about 1 1/8" wide. The blade angle appears to be the standard angle in that it matches the #3 bedrock I compared it to (45 degrees?).
I would say it's about 5-6" long, so what size would this be equivalent to, and can I get an iron for it?
269534
I got a wooden plane body from my father-in-law's garage, no iron, no wedge. It is a tiny little thing but I'd like to make it functional. The mouth has rounded ends like it was either drilled or routered out and the flat part is about 1 1/8" wide. The blade angle appears to be the standard angle in that it matches the #3 bedrock I compared it to (45 degrees?).
I would say it's about 5-6" long, so what size would this be equivalent to, and can I get an iron for it?
269534