Paul Berendsohn
05-26-2005, 9:33 AM
A friend directed me to a very glowing review of the EZSmart in "Tools of The Trade", a publication I think we can all agree is utterly without bias.
Some of the high points:
"Eurekazone's E-Z Smart Guide 100-inch SGS-1 is a 21st century extruded aluminum version of that classic jig."
"Eurekazone's well-designed undermount clamp system makes using the E-Z Smart Guide system easy and accurate."
"To make the SGS-1 a full 100 inches long, you spline the two 50-inch guide pieces and secure them together with Allen screws. They hold tight and the guide is dead straight."
"enabled me to make dead-straight bevel cuts on any shelf stock—both along the end or for full-sheet rips."
(Hopefully it's OK to post a link to the entire article?)
http://www.toolsofthetrade.net/articles/showarticle.asp?articleID=2264&position=1&type=article&partID=1
Nice to see the hard work paying off Dino...
Paul
Some of the high points:
"Eurekazone's E-Z Smart Guide 100-inch SGS-1 is a 21st century extruded aluminum version of that classic jig."
"Eurekazone's well-designed undermount clamp system makes using the E-Z Smart Guide system easy and accurate."
"To make the SGS-1 a full 100 inches long, you spline the two 50-inch guide pieces and secure them together with Allen screws. They hold tight and the guide is dead straight."
"enabled me to make dead-straight bevel cuts on any shelf stock—both along the end or for full-sheet rips."
(Hopefully it's OK to post a link to the entire article?)
http://www.toolsofthetrade.net/articles/showarticle.asp?articleID=2264&position=1&type=article&partID=1
Nice to see the hard work paying off Dino...
Paul