allan kuntz
08-03-2013, 6:44 PM
I think I have the Canadian equivalent to the Laguna A175017 before it went to the 1-1/4 spindle
http://www.lagunatools.com/lathes/lathe-1847#
I have a problem . It keeps cutting out. It will run for awhile and then there is small clunk and then slows down to zero rpm. Once it has settled back to zero rpm it will start again run for awhile,another small clunk and then back to zero. The clunk seems to be coming from the motor. This happen at various speeds and never runs for a set time. Sometimes it runs for a long time sometimes it will not even get up to speed. Even when it runs for awhile it does not get up to full speed. Only 2200 rpm on the high speed belt setting. It does it with the belt on or off so it can't be a spindle problem.
Here is a link to my lathe but Busy Bee has also gone to the 1-1/4 spindle
http://www.busybeetools.com/products/WOOD-LATHE-18IN.-X47IN.-W%7B47%7DDIG-READ-OUT-CT128N.html
Any help or suggestions would be appreciated
Thank you
Al
http://www.lagunatools.com/lathes/lathe-1847#
I have a problem . It keeps cutting out. It will run for awhile and then there is small clunk and then slows down to zero rpm. Once it has settled back to zero rpm it will start again run for awhile,another small clunk and then back to zero. The clunk seems to be coming from the motor. This happen at various speeds and never runs for a set time. Sometimes it runs for a long time sometimes it will not even get up to speed. Even when it runs for awhile it does not get up to full speed. Only 2200 rpm on the high speed belt setting. It does it with the belt on or off so it can't be a spindle problem.
Here is a link to my lathe but Busy Bee has also gone to the 1-1/4 spindle
http://www.busybeetools.com/products/WOOD-LATHE-18IN.-X47IN.-W%7B47%7DDIG-READ-OUT-CT128N.html
Any help or suggestions would be appreciated
Thank you
Al