View Full Version : Rockwell 46-111
James Bucci
08-01-2013, 12:47 PM
I recently bought a vintage Rockwell 46-111 lathe . It has a one inch 8tpi shaft on the head stock . I can not thread on the face plate that came with lathe nor can I thread on an 8 tpi Oneway chuck adapter . Does anyone have any advice ?
Marvin Hasenak
08-01-2013, 1:13 PM
The threads are buggered up, usually because it or something was dropped n the threads. I would try to find a 1-8 die and clean the threads up.
Ron Faraday
05-11-2023, 3:29 AM
Check the diameter again. It may be a 7/8".
Robert Hayward
05-11-2023, 10:35 AM
Ron, do you realize this thread is just a little short of ten years old? Marvin has not logged into this site in a little over a year.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.