Dee Gallo
07-31-2013, 8:46 PM
Hi all,
I just bought some no-odor rubber from Laserbits. My manual says that you should use raster-only when you want to engrave thin lines (.001-.007 or .7 points-.5 points) instead of cutting.
My question is: When you are in stamp mode, will thin half point lines engrave? I have always thought that .5 lines would only cut.
If anyone has experience with this, I'd appreciate your input to clear this up before I waste my rubber!
thanks, dee
I just bought some no-odor rubber from Laserbits. My manual says that you should use raster-only when you want to engrave thin lines (.001-.007 or .7 points-.5 points) instead of cutting.
My question is: When you are in stamp mode, will thin half point lines engrave? I have always thought that .5 lines would only cut.
If anyone has experience with this, I'd appreciate your input to clear this up before I waste my rubber!
thanks, dee