Dust Collection Positions for SLiding Compound Niter saw

[tim walker]

So I have built my dust shroud and am positioning it for 2-4" duct collection ports. I am hooked up to a Clearvue Cyclone so air movement not an issue. The dust shroud is 5 sided. I have placed one outlet at the rear center bottom. I am trying to decide on the second outlet. I don't know id it should go on a side down low, in the back center but higher, or out the top.

Any suggestions form those that may have set tehre tools up?

[James Baker SD]

I don't have an answer, but I am interested in what others think, so I will bump this thread.

[Andy Pogue]

Do you have pictures? I have kicked around several ideas, but haven't come up with anything I like.