Trotec Cutting Settings

[Eddie Castaneda]

I'm trying to cut out a Stencil for my shop, everytime I try to just cut the Stencil it loads it like normal but I go to Cut it just beeps as if its done. Any Ideas?

[Mike Null]

My guess is that your cutline is too wide or you don't have the job control set to cut or you are using the wrong color. You can cut with many colors but I would set red as the default and be sure the job control on that color is set to cut rather than engrave.

[Eddie Castaneda]

Mike I just tried to cut it with black but no dice I will try Red and see what happens also do I have to use it with the black? Thanks for the help

[Tony Lenkic]

+1 what Mike said. Also make sure your cut lines are set to hairline and colors are RGB.

[Mark Sipes]

You should be able to see the layout in Job Control befor the job runs. Make sure the material cut parameters are set to cut for the color you selected and that the lines in the art work are less than .005 thick.