PDA

View Full Version : Cermark for glass and tile



Ken Smith Jr
06-21-2013, 7:20 AM
Has anybody gotten any good results on glass (Beer mugs etc) with this stuff? Been messing around trying to get it to work and seem to be either etching through to the glass or not etching anything at all, would the power be that sensitive to either hit it or over engrave it? Thank you!!

Chuck Stone
06-21-2013, 12:11 PM
might be worth an experiment to etch lightly at first, then brush out the chips
and apply the Cermark. Then run the laser again, below the power needed to
etch? Don't know if that's even cost efficient, but worth trying on a piece you've
already ruined.. seems like the etched surface might give it something to grab.