View Full Version : Looking for resaw fence for a 20" Rockwell
Jack Graham
06-14-2013, 3:33 PM
I have a Rockwell Model 20 Vertical Band saw, 28x 3X0, serial number 1810285. The table is 20 inches wide and 24.25 inches deep.
I would like to locate a good resaw fence. Any suggestions?
Jack Graham, San Marcos TX
Calvin Jamison
06-14-2013, 4:53 PM
Carter makes a magnetic fence that will fit just about any bandsaw. It has super strong magnets that don't move easily. Delta makes a smaller uni fence for bandsaws. You could always just make one, they're not super difficult.
Dan T Jones
06-14-2013, 4:55 PM
Jack,
I'm working on a 18" Parks and planning to build the following fence:
http://americanwoodworker.com/blogs/shop/archive/2009/10/26/bandsaw-fence.aspx
It allow for drift adjustment and allows you to use your miter slots.
Dan
Calvin Jamison
06-14-2013, 5:07 PM
If you adjust your blade tracking to where the gullet of the blade rides just a little bit in front of the crown (whoch gives better support to the tooth) and have proper blade tension you should never have drift, ever ( unless your blade is hosed).
Tai Fu
06-14-2013, 10:52 PM
What about the grizzly resaw fence? I really like it. They should have one for 20 inch tables...
Scott Haddix
06-15-2013, 10:44 PM
I've been really happy with my Laguna DriftMaster fence on my 19" Grizzly bandsaw. I have both the short and tall fences, and the combo covers all of my needs.
John Bailey
06-16-2013, 1:11 AM
I had a lot of trouble with finding a proper fence for my Oliver. I finally bought a couple of 40mm MagSwitches and they have worked perfectly.
Paul Incognito
06-16-2013, 6:50 PM
I did the same thing for my Crescent Heavy 20, John. Made a pretty respectable rip fence from some scraps and a couple of MagSwitches.
Paul
Jack Graham
06-17-2013, 9:31 AM
Thanks for all you ideas. I will look into all and advise you what I ended up doing. Thanks again. Jack Graham
Dave Cav
06-20-2013, 11:34 PM
If you can find a used Unifence, they make a pretty good fence for a Rockwell 20". I put one on our saw at school when I upgraded the Unisaw to a Bies. Lots of people have done that so you might not have too much trouble finding one.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.