Emma austin
06-03-2013, 4:01 AM
Hey all, went to do some cleaning on the machine, and to get out the exhaust plenum thing I need to raise the laser bed all the way up. Did this, and couldn't get it out, took a while to figure out it wsn't all the way up! (didn't notice as use a honeycomb tray which makes it higher, so never have it all the way up except to clean).
It didn't sound like it was fighting to get up further, it just wouldn't go any further, as if it was already at the top.
Then started notcing sounds coming from the right hand side that it may be struggling to move up and down freely. I can't see anything obstructing it, but I haven't really opened anything up, I wouldn't know where to start.
Will be calling our rep (who lives in another city) tomorrow so hopefully he has some ideas.
Anyone had anything like this?
Thanks
It didn't sound like it was fighting to get up further, it just wouldn't go any further, as if it was already at the top.
Then started notcing sounds coming from the right hand side that it may be struggling to move up and down freely. I can't see anything obstructing it, but I haven't really opened anything up, I wouldn't know where to start.
Will be calling our rep (who lives in another city) tomorrow so hopefully he has some ideas.
Anyone had anything like this?
Thanks