Vicmarc VL300 dimensions needed

[Neil Bosdet]

Hi all,

I'm installing the floor on my new shop and want to beef up the area for my lathe. I'm getting a Vicmarc VL300 used from someone. It will be shipped so I have no access to it until I receive it. Hoping a VL300 owner could kindly measure the dimensions of the feet. i.e.: how far apart are they, width and length? It is a Vicmarc base I believe, not a Craft Supplies base. I don't know if the two are the same or not regarding dimensions.

Thanks,

Neil

[John Beaver]

It's metric but it's on their website. vicmarc.com

[Neil Bosdet]

Actually it's not on their website. I've gone through a couple of times. Downloaded the manuals too.

Anyone else?

Neil

[John Beaver]

Since I suggested it, I figured I better find it. If you click on the lathe, it's the last item under specifications.

From their website. VL300s - shortbed

Length x Width x Height 1150x790x1480mm equals 45x31x52 inches

Good Luck,

John

[Neil Bosdet]

That's the shortbed. I'm getting the longbed. But this helps. Thanks.