Lee Alkureishi
05-13-2013, 12:40 PM
Hi,
I'm new to metalworking, so please forgive me if this is a ridiculously simple question/answer.
I'm building a woodworking bowl lathe stand, and a riser for the headstock. The riser is 4 steel tube columns with angle iron welded to the top to act as ways.
I'm not sure if my clamping was off, or the iron deformed from the welding heat, but the top surface is no longer flat - rather, it has a slight crown toward the center.
I'm wondering the best way to flatten the top surface/have the 2 pieces of angle iron in the same plane. I was planning to use an angle grinder to get it close, then a file. I'm thinking it'll be a lot of workdo i wanted to ask if there's a better way before i start!
Thanks in advance,
Lee
I'm new to metalworking, so please forgive me if this is a ridiculously simple question/answer.
I'm building a woodworking bowl lathe stand, and a riser for the headstock. The riser is 4 steel tube columns with angle iron welded to the top to act as ways.
I'm not sure if my clamping was off, or the iron deformed from the welding heat, but the top surface is no longer flat - rather, it has a slight crown toward the center.
I'm wondering the best way to flatten the top surface/have the 2 pieces of angle iron in the same plane. I was planning to use an angle grinder to get it close, then a file. I'm thinking it'll be a lot of workdo i wanted to ask if there's a better way before i start!
Thanks in advance,
Lee