View Full Version : General Metalworking I built and machined a bench grinder
curtis rosche
05-02-2013, 6:13 PM
Here one of my current projects, its a bench grinder. The base and sheilds are cast aluminum, the rest is steel. started from billet aluminum, sheet steel, and a 3/4 round bar. Its almost done, but not quiet.
Lornie McCullough
05-02-2013, 8:16 PM
Nicely done!
Had to subscribe to this thread so I don't miss your next installment. I can hardly wait to see the finished grinder.
Lornie
curtis rosche
05-02-2013, 9:57 PM
I wish I couldve taken pictures in the lab at school casting the parts and doing some of the machining, but the semester goes fast and theres not much time for that
Jerry Marcantel
05-03-2013, 11:25 AM
Curtis, nice job. When do you think you'll be done? ....... Jerry (in Tucson)
curtis rosche
05-03-2013, 12:59 PM
I have till thursday to get it done, not including paint
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.