Cailline Lea
04-29-2013, 5:07 AM
Firstly, I would like to say Hello :0) to everyone here. It is my first time posting and the level of expertise and skill sharing is immense and its great to be a part of that.
I was hoping that I could tap in to that knowledge for a little help for a problem that keeps occurring.
I have a British made 80watt laser that has the Chinese software Lasercut5.3.
The problem: If I engrave a shape and then want to put a vector line around the perimeter of the shape to give added definition the vector line is out by 1mm to the left so it is going through the engraved shape.
I have checked the laser alignment, checked that the mirrors in the laser head are secure and are not wobbling about but cannot seem to get is to skim the edges neatly.
Thanks in advance for any help :0)
I was hoping that I could tap in to that knowledge for a little help for a problem that keeps occurring.
I have a British made 80watt laser that has the Chinese software Lasercut5.3.
The problem: If I engrave a shape and then want to put a vector line around the perimeter of the shape to give added definition the vector line is out by 1mm to the left so it is going through the engraved shape.
I have checked the laser alignment, checked that the mirrors in the laser head are secure and are not wobbling about but cannot seem to get is to skim the edges neatly.
Thanks in advance for any help :0)