Biff Johnson
04-24-2013, 1:14 AM
Hoping there is an electrician or someone sharper on motor wiring than I.
i have an old Dayton 4K856 motor that was on my 50's era Delta lathe. It did run but I upgraded motors. Flash forward to today and I want to use this motor in another machine. It is a 3/4hp,1725rpm,115/230 volt.
The wiring schematic is gone and the current model of this motor at Graingers have a different wire setup. The set up is six wires, 4 black and two white. The blacks are numbered 1,2,3,4 and the whites are 5,8.
i have no clue which wires to attach for 115 volt operation. I've googled it but found nothing that matches this wire number or coloring. Any ideas?
i have an old Dayton 4K856 motor that was on my 50's era Delta lathe. It did run but I upgraded motors. Flash forward to today and I want to use this motor in another machine. It is a 3/4hp,1725rpm,115/230 volt.
The wiring schematic is gone and the current model of this motor at Graingers have a different wire setup. The set up is six wires, 4 black and two white. The blacks are numbered 1,2,3,4 and the whites are 5,8.
i have no clue which wires to attach for 115 volt operation. I've googled it but found nothing that matches this wire number or coloring. Any ideas?