PDA

View Full Version : Cermark on China Plates



Mike Johns 1970
04-22-2013, 8:18 PM
I am struggling with the Cermark for tile/glass. Attached is a picture of a plate I did for a Client and I am not happy with the results. I used 20% speed and 45% power (this was the best result I got after a lot of playing.) Is this the kind of result I should expect?

Thanks,
Mike

Mark Sipes
04-22-2013, 8:59 PM
Tell us about your equipment.. 45% of what.......25 watt or 250 watt

and you are using Ferro RD-6044 for glass/ceramic

And Welcome to the forum......

Mike Johns 1970
04-22-2013, 10:21 PM
Oops. 40 watt and yes Ferro rd-6044.

Thanks

Dan Hintz
04-23-2013, 5:48 AM
I used 20% speed and 45% power (this was the best result I got after a lot of playing.)

This is not nearly enough power for a 40W...

John Salitsky
04-23-2013, 3:11 PM
I always check with the manufacturer of these chemicals for suggested machine settings. They are not always a 100% accurate due to variations of one thing or another but they are usually pretty close and it will save you a ton of time and waste of product.

Mark Sipes
04-23-2013, 3:46 PM
In defense of Mike....... I think he did..



Recommended Starting Point for Settings

CO2: 30-50% power (35 watt laser)
10-25% speed
500 DPI / 500 PPI
YAG- 10-20 watts
10-20 inches/sec speed

Martin Boekers
04-23-2013, 5:38 PM
You might want to check these guys out. The system is fairly expensive to get set up, but they will do one ups
in full color reasonably priced. These images are permenant! Even full sun outdoors. Similar process to photos
on tiles for cemetaries.

Haven't had a chance to use them yet, but this is one of those things you file away til the day a client comes
and asks for it!

http://www.enduring-images.com/?gclid=CNDO5Ynf4bYCFaYWMgoddUIAdQ

Mike Johns 1970
04-23-2013, 9:12 PM
I tried the settings from laserbits where I bought the cermark. 100 power and 28 speed. Turned out horible. I then dialed the power down 10 percent at a time while keeping the speed slow. I got down to 45 or so and that was best. It also meshed best with the cermark posted settings. The client loved it but I want a better result. I will keep trying.

Thanks.

John Salitsky
04-24-2013, 9:55 AM
Yeah I had to adjust the setting they suggested a bit in order get it as black as possible. I was lasering the blade of a steak knife and while it got darker and was acceptable to the customer I found myself wanting it darker. It still seemed sort of gray to me.