Richard G. Jackson
04-19-2013, 8:12 AM
Good morning everyone,
I was recently presented with a Grizzly tablesaw Model G1022. It is a 10 inch, Tilting Arbor saw that was purchased in Jan. 1989, and it is in dire need of a tuneup. My question is, should I take the time to disassemble this GEM and does anyone here have any experience with this saw? I can list the things that I see that need attention, but I'm sure that there are many things I don't know about. Do you think the good folks at GRIZZLY would have any pointers in getting this tool operating safely again?
Thanks for any help you can offer me.
Rick
I was recently presented with a Grizzly tablesaw Model G1022. It is a 10 inch, Tilting Arbor saw that was purchased in Jan. 1989, and it is in dire need of a tuneup. My question is, should I take the time to disassemble this GEM and does anyone here have any experience with this saw? I can list the things that I see that need attention, but I'm sure that there are many things I don't know about. Do you think the good folks at GRIZZLY would have any pointers in getting this tool operating safely again?
Thanks for any help you can offer me.
Rick