Jerry Thompson
04-18-2013, 5:12 PM
I had some 30'' sides to my Shaker clock that were not square due to me not checking my SCMS in ages. I squared them up amd redid the rabbets. This ended up with them needing to be cut to equal length and back of the clock shortend also. Ony a tiny bit needed to be removed. I shaved of a hair on all three. I stood them vertical and they were within 1/128'' of each other.
Tomorrow I am going to EBay all of my measuring devices. Just think of the time I will save not hunting for my tape measure. The thing was off half the time anyway.:D
Tomorrow I am going to EBay all of my measuring devices. Just think of the time I will save not hunting for my tape measure. The thing was off half the time anyway.:D