Barry Munsell
04-18-2013, 12:17 PM
I'm using a Rockler Jig for drawers with 3/4" sides front and back. I want the half blind dovetails to be half the thickness of the side or 3/8" deep, but it seems that the jig with a 1/2", 14 degree bit will only allow a 1/4" deep joint. Am I missing something? The weird thing is that I built a whole kitchen full of drawers on a borrowed Rockler Jig a couple of years ago that I thought was identical to the one I bought and those half blind joints are all 3/8" deep, I've gone back and measured them. Any suggestions?