View Full Version : faceplate
Ross Williams
05-11-2005, 1:48 PM
can anyone please tell me where I can get a 5/8" 11 tpi faceplate?:eek:
3 inch or so.
Bill Lewis
05-11-2005, 1:50 PM
I think Record has them for their lathes. Old craftsman too. I'm drawing on memory so I could be mistaken.
Ross Williams
05-11-2005, 1:55 PM
thanks...Im new at this so any help will be good..the spindle is 5/8 11 tpi ,can I even get an addaptor to make it 1" 8 tpi so it will be easier to get stuff?
Jim Becker
05-11-2005, 4:35 PM
Bestwood Tools can help you out.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.