View Full Version : "Clip Box" only cutting 3 sides
Amos De Pasquale
03-25-2013, 4:42 AM
I am using LaserCut 5.1, when I run "Clip Box" it is supposed to CUT the outside frame, however, the first side it does is at a very quick speed and does not cut, the other 3 sides are ok, any suggestions on settings??! Thanks Amos
Scott Challoner
03-25-2013, 11:31 AM
I don't know about LaserCut, but if you had your box directly on one of the axis in Corel, it wouldn't cut. Make sure you're box isn't directly butted up against the x or y axis.
Amos De Pasquale
03-26-2013, 2:15 AM
Thanks Scott, but no, the box isn't directly butted against the x or y axis, Amos
Greg Holt
03-26-2013, 5:51 AM
Amos
I don't use LaserCut but in a lot of ways it is similar to LaserCAD, which I do use.
In LaserCAD there is the option to choose the origin. It is called "Position Relative". See Pic.
If LaserCut has something similar, does it make any difference if you select a different origin?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.