Another TS question...

[Jon Wilson]

As I learn more and more about using my TS I'm running into more and more issues

So, In an effort to make Dado'ing go a little faster I bought a dado stack set. Now I need a dado insert.

I have a (don't you dare laugh) Skil 3310 10" TS with a 7" dado set

Can I make a (safe to use) insert or am I forced into paying the near $30 that the insert costs.

For anyone that may feel inclined to look, the part number is 80077

edit: I attached a picture of the insert.

Thanks! (again)

[Rod Sheridan]

Hi Jon, if you can make an insert with clips, or wood tabs to hold down the end, then you're going to be fine.

When I had a tablesaw I often made inserts for mine.............Rod.

[Jon Wilson]

Thanks. I guess what I was really asking is, can I do it safely.

because we all know, with the right amount of want, a dremel and plenty of duct tape you can make anything. :)

[John Donofrio]

Hi Jon,

My old tablesaw was a craftsman job site saw with an insert very similar, if not the same, as the one you show. I made inserts for it with 3/8" plywood. To simulate the clips in the rear I used small dowels placed into the back of the insert, filed flat as required. The inserts worked well and were safe.