PDA

View Full Version : Hi folks



Anthony Yakonick
05-07-2003, 10:52 PM
I'm new here, Mr Becker gave me a tip about the forum and I like the setup. I have been turning for 9yrs but lately I've cleaned off my tablesaw and have a desire to do some flat stuff but my passion is still turning.

Thanks, Anthony

Von Bickley
05-07-2003, 10:56 PM
Anthony,

Glad to see you at the Creek. We have a lot of good people that hang out here, and they all enjoy wood-working. Hope you will jump in on our discussions and perhaps post some pictures of your turnings.

Charles McKinley
05-07-2003, 11:01 PM
It is a great place to wade in.

Ken Wright
05-08-2003, 8:12 AM
Glad to have you here .... good group of folks and lot'sa PA folks to keep you company!!

I thought the transition to turning was a one way street??? Never seen any of these folks make the transition from flat boards to turning and then come back.....:D

Dave Avery
05-08-2003, 9:02 AM
Hi Anthony,

Nice to have you here. Dave.

Jim Becker
05-08-2003, 9:03 AM
Originally posted by Ken Wright
I thought the transition to turning was a one way street??? Never seen any of these folks make the transition from flat boards to turning and then come back.....

While it can be difficult, sometimes SWMBO wants things that are not round...like a new kitchen or bedroom or dining room, etc. You just have to justify things in creative ways sometimes.

I'll admit that turning is a true addiction for me, but I also have a passion for furniture making. Part of the solution is to combine both, such as a chair project...which is about the only way I'll ever force myself to make a whole bunch of thin spindles!

Welcome to Anthony!

Jim Fuller
05-08-2003, 9:13 AM
We have fun here and look forward to your contributions.

Ken Salisbury
05-08-2003, 9:21 AM
<p align="center">
<IMG src="http://www.klsal.com/welcomeplane.gif">

"Your Friendly Moderator"

Jay Albrandt
05-08-2003, 11:35 AM
Hi Anthony,

I'm sure you will enjoy the forum. If you get around to it, post some of your work, and a shop tour. See you around.

Jay

Jim Stastny
05-08-2003, 11:36 AM
Nice to have you here.:D

Glenn Clabo
05-08-2003, 12:06 PM
Welcome Anthony

Don't forget to wipe your feet on the way out...lots of sawdust being made....

Dave Arbuckle
05-08-2003, 12:39 PM
Ken Wright wrote: I thought the transition to turning was a one way street??? Never seen any of these folks make the transition from flat boards to turning and then come back.....

Dave holds up hand. I put the lathe away about a year and a half ago, haven't turned anything since.

Welcome, Anthony. This Mister Becker guy any relation to Jim over there? ;)

Dave
(also stopped smoking cold turkey)

Tom Sweeney
05-08-2003, 2:05 PM
Hello from another SE PA'er.

Welcome to the Creek. Pull up a log & hang out a while.

Lot's of friendly knowledgeable folks here - you'll fit right in.

Anthony Yakonick
05-08-2003, 9:47 PM
Thanks for the welcome. The reason for the partial change over is due somewhat to health reasons, two carpel tunnel surgerys a few years ago and I'm still out of work due to shoulder surgery two weeks ago. I think flat work is a bit easier on my body. Plus I like building things for the house and 99% of my turnings are sold at shows. Thanks once again.

Anthony