John M. Cioffi
05-03-2005, 10:29 AM
Hi ALl,
For all you who have purchased the Delta splitter...or those who would know...
There was a thread recently on how to install,but I ran across a problem that was not determined. My tablesaw is perfectly square & has always cut dead on straight throughout the cut. I removed the existing splitter assembly that came with the saw & set up the new splitter & installed with the 2 cap screws in the same holes in the trunion frame. So, the result of this is that the splitter is 1/16th off - to the left of my blade. There are no adjustments to make. I already tried to move the trunion, but the splitter mount moves with it. I had to re-square everything again. What's up with that!!??
Does anyone have the answer to this?
I have a right tilt contr.saw-(the Delta Grand White).:confused:
Thanks,
John
For all you who have purchased the Delta splitter...or those who would know...
There was a thread recently on how to install,but I ran across a problem that was not determined. My tablesaw is perfectly square & has always cut dead on straight throughout the cut. I removed the existing splitter assembly that came with the saw & set up the new splitter & installed with the 2 cap screws in the same holes in the trunion frame. So, the result of this is that the splitter is 1/16th off - to the left of my blade. There are no adjustments to make. I already tried to move the trunion, but the splitter mount moves with it. I had to re-square everything again. What's up with that!!??
Does anyone have the answer to this?
I have a right tilt contr.saw-(the Delta Grand White).:confused:
Thanks,
John