Shenhui error message help

[Walt Langhans]

Hi all,

I'm getting and error message on the control panel of my machine the reads:

No Enough
Extend Space
Please Esc

What the heck does that mean? I'm getting this message in the middle of my material that is also in the middle of the design in corel, so it's not that the object is off the page.

Thoughts?

[Khalid Nazim]

In RDCAM do a select all to see if you have any lines that are not visible to you (could be small dot or line) and are causing the object to be bigger than what you see. If the boundary of your selection is the same as your objects then you have eliminated one reason for the problem.

I have faced similar situation in the past and one way that I got rid of this error message was to do a full restart of Laser and PC and send the file again. Let me know if that works for you.

Regards
KN

[Walt Langhans]

I don't see anything visible outside of the area, I'll try the restart and see what happens

[Zlatko Kursar]

I get this message when my object for engraving is on full left or right side. Then the head don't have enough space to go left or right because it is end point of
X axis.

P.S. Sorry for my english :)

[Walt Langhans]

I found out what the error is, I updated the tips and tricks thread.