Jim Eller
02-05-2013, 9:59 PM
I have a feeling that nothing is wrong but need to verify.
I just purchased a Powermatic PM 701 mortiser. I sent it up and just did a couple of test holes.
When shutting the thing off, there is a "click" in the motor just before the bit stops rotating. I did it 3-4 times with the same results.
Is this normal? I couldn't find anything is the manual that addresses this.
Thanks,
JimE
I just purchased a Powermatic PM 701 mortiser. I sent it up and just did a couple of test holes.
When shutting the thing off, there is a "click" in the motor just before the bit stops rotating. I did it 3-4 times with the same results.
Is this normal? I couldn't find anything is the manual that addresses this.
Thanks,
JimE