Walt Langhans
02-05-2013, 12:32 PM
Hi folks,
In Laserworks under the config tab, is an area that says 'Export Setting' and then has 'Export Precision %' and the default is set at 80. Anyone know what this setting does?
I just tried to run a very large, very detailed files, and the laser missed areas, but the drawing in corel is fine. I'm wondering if this might be the problem.
Thanks
In Laserworks under the config tab, is an area that says 'Export Setting' and then has 'Export Precision %' and the default is set at 80. Anyone know what this setting does?
I just tried to run a very large, very detailed files, and the laser missed areas, but the drawing in corel is fine. I'm wondering if this might be the problem.
Thanks