Mohammed Issa
02-04-2013, 2:40 PM
hi everyone,
i have been getting clues from reading around the posts in this forum that some chinese laser owners were able to embed the Laserworks software into CorelDraw.
i am not really sure if i have ready correctly. Im not even sure if that is even possible.
i extensively searched for a how-to post on this, but couldnt find anything.
can anyone give me more info on how that can be done, if it is even possible?
the reason i am asking is that, it is very frustrating to keep exporting from CD and then importing into LW. and LW crashes a lot, its not very reliable, it simply doesnt compare to CD.
here is the setup i have:
Windows XP
CorelDraw X6
LaserWorks V5
Chinese 530 60W Laser
any help would be greatly appreciated,
Thanks!
i have been getting clues from reading around the posts in this forum that some chinese laser owners were able to embed the Laserworks software into CorelDraw.
i am not really sure if i have ready correctly. Im not even sure if that is even possible.
i extensively searched for a how-to post on this, but couldnt find anything.
can anyone give me more info on how that can be done, if it is even possible?
the reason i am asking is that, it is very frustrating to keep exporting from CD and then importing into LW. and LW crashes a lot, its not very reliable, it simply doesnt compare to CD.
here is the setup i have:
Windows XP
CorelDraw X6
LaserWorks V5
Chinese 530 60W Laser
any help would be greatly appreciated,
Thanks!