PDA

View Full Version : Laserwork question



Walt Langhans
02-03-2013, 11:47 AM
Hi folks

I'm using CorelDraw x5 and have laserworks (RDCAM) 6.0.08 as a plug in to talk to my laser and I can't figure out how to tell it once it is done with a job to move the laser head back to home position. Any ideas?

Thanks

A little more info. If a draw a square in the middle of the page in corel and that's the only object, the machine moves to that position, makes the cut and then stays there. But if I draw a square in all four corners in corel the machine makes the cut, and then returns to the upper most left position (which I'm fine with). It seems that unless I'm using the entire area in corel laserworks dosen't seem to recognize that there is the rest of a page there. If that made sense.