Walt Langhans
01-30-2013, 12:49 PM
Hi everyone!
This is probably a stupid question but I'm going to ask it anyway ;)
Once you have aligned your laser via the tape on the mirror method, how do you check that everything else is good? Meaning if I cut/ engrave a circle or square in the right bottom corner of my area and it comes out ok is it safe to assume the rest of the bed will be ok or should I engrave some kind of pattern over the entire area?
Thanks
This is probably a stupid question but I'm going to ask it anyway ;)
Once you have aligned your laser via the tape on the mirror method, how do you check that everything else is good? Meaning if I cut/ engrave a circle or square in the right bottom corner of my area and it comes out ok is it safe to assume the rest of the bed will be ok or should I engrave some kind of pattern over the entire area?
Thanks