Desktop name plate

[Eric Seest]

Does anyone know where I can get blank Desktop name plates like the ones in the picture? I normally cut them myself but the customer wants some that don't require a holder. I have done several searches but just find places that sell them engraved.

[Ray Beaty]

www.johnsonplastics.com

[Joe Pelonio]

If there will be a good quantity, buy a strip heater. You just cut them twice as high, engrave and bend. You can even do it with a jig and heat gun. At Johnson it's $126 but TAP has the replacement strip for $79 if you want to make your own.

[Ross Moshinsky]

These are engraved then bent in a brake (like aluminum siding)

[Ross Moshinsky]

at 1st I thought they were aluminum and brass but now I see that they are plastic. The more likely process is heat and bend as stated by Joe.

[Bert Kemp]

Does anyone know where I can get blank Desktop name plates like the ones in the picture? I normally cut them myself but the customer wants some that don't require a holder. I have done several searches but just find places that sell them engraved.

Try here http://www.nametagcountry.com/category/Desk_Name_Plates_Holders