William Noyer
01-06-2013, 9:56 PM
Hey all- I had searched for this for a project I had for a customer and couldn't find one I liked, even paying for it. So, I did it "old school" and traced it by hand. I am not they greatest tracer but the customer was happy, so that is all that mattered. Just thought I would share it so if anyone else needed it they could have it. I wasn't sure if there was a repository on here for shared graphics, so here it is. I will also include my test run of the project on a scrap piece of pine so you can see it engraved. I am going to do the final product on a piece of alder with walnut trim. I will post the finished product once the customer pays and I run it.
Bill
250341
Well, I will share when I can figure out how to get the forum to let me attach it. It is only a 1mb file, but when I try to upload it it gives me an error that the file type is too large.
Bill
250341
Well, I will share when I can figure out how to get the forum to let me attach it. It is only a 1mb file, but when I try to upload it it gives me an error that the file type is too large.