Don Welch
12-29-2012, 6:34 PM
With the addition of a jointer / planer we need something beyond the Fein Turbo II & Clearvue Minim combo being used on my son's Unisaw. It would be desirable for this to be a mobile point of use system with a cyclone and 110V operation. There're one each 30A and 20A 220V receptacles available in the garage so the system could be 220V if there's not a good 110V solution since it's planned to be moved from machine to machine - just be nice if it wasn't. There seems to be a gap between the small shop vac cyclones and a big step up, the CV1800, likely since the step above the shop vac route often involves hard plumbed stationary systems. My question isn't - is this the optimum performance route [already know it's not] but has this or similar been done by anyone and how acceptable were the results?