Manual for New Hermes B-6 Beveler

[John Jackson]

Hi,

I am searching for a PDF manual for a New Hermes B-6 Beveler I recently acquired. I know how use it as an edge beveler, but since it came with a set of corner rounding plates I would like to know the correct setup for these.
Thanks!

John Jackson
Russell, ON

[Mike Null]

John

I have that beveler but no manual. The corner rounding jigs fit into the the hole on the table in front of the cutter and you rotate them.

I found that I needed ear protection more than anything else with this machine.

The adjustments are fairly obvious but it is important to clean it out as soon as the vacuum starts leaving bits on the table. You might clean and wax the table so the material slides better and make yourself a pusher so that you can push the material through smoothly and keep your fingers out of the way.

[Tony Lenkic]

John,

Have you called Engraving Depot in Missisauga, On.?
Give Russell Sadler a call.... he may have it or point you in right direction where to get one.
Google search.....engraversdepot dot com

[John Jackson]

Thanks Tony - I will do that after Christmas.